A quick how to video on the application of preformed thermoplastic. In this video we are applying ThermaMark R115 premium grade thermoplastic, but the same application methods apply for preformed directional markings. Preformed thermoplastic is an extremely effective way of marking out parking bays or roadways around your facility with the use of a gas torch.
1. Surface Preparation
Clean the area of the surface to be repaired. Brush away any loose stone or debris from the area and remove any sand, dire or oily substances. For installation you will need:
- ThermaMark (in this video we are using R115 preformed line)
- Gas Torch we recommend The Hornet
- Broom
- Stanley Knife
-
Protack
2. Pre-heat The Area
Using a suitable propane torch, we recommend The Hornet, remove all moisture present (if any) pre-heat the area thoroughly prior to treatment.
3. Apply ProTack Aerosol
Spray the area you are about to lay the lines down on with ProTack Aerosol to improve the adhesion between the tape and surface.
4. Application Of The ThermaMark
Roll out the tape on the area that has been both pre-heated and sprayed with ProTack, then cut to size.
5. Heat The Thermoplastic
Heat the ThermaMark using a propane torch keeping the flame approximately 20-40cm from the tape. Do not concentrate the heat in one area and heat with an even sweeping action. Heat until the tape starts bubbling and flowing into the road surface.
6. Heat Until Fully Molten
A closer inspection of what the tape should look like when heat is applied correctly.
REMEMBER!
Clean, dry surfaces are important for adhesion. When heating the ThermaMark ensure you keep an even sweeping action.
